Fire stopping between a restaurant and the flats above
- Every seal labelled and photographed
- BM TRADA / FIRAS-certificated contractors
- Written price before any work
Stand in the kitchen of a small West End restaurant and look up. Above the canopy, a galvanised extract duct goes straight up through the ceiling. Beside it, a gas pipe heads for the upstairs boiler, a 110mm soil pipe comes down from the flat bathroom, and a bundle of cables disappears into a hole someone made with a hammer.
On the other side of that ceiling is the floor of somebody's flat.
The floor between them is a fire separation, and every one of those openings has to be sealed to suit it.
The extract duct is a special case. Kitchen extract ducts carry grease and can catch fire inside, so how they are built and protected is a job for the ventilation designer and installer, and may involve fire-rated ductwork or a protected shaft. The fire stopping round the outside of the duct, where it passes through each floor, still has to be done with a system tested for that size and type of duct.
The soil pipe, if plastic, needs a collar on the restaurant side. The gas pipe needs a seal suited to steel or copper. The cable bundle needs batt and mastic or a cable sealant, and some of those cables may be dead and can come out.
When the ceiling of the restaurant is opened, it is also worth looking at the stair wall, if the flats share a stair that runs beside the restaurant. That wall is the escape route for everyone upstairs.
Restaurant ceilings get covered over at every refit. The best moment to seal them is when they are open.

Tell us the street, what the building is used for and send a photo. We will say what it needs and roughly what it costs.